Standing seam and metal panel roofing, roof repair and full replacement in Hartford. We show up when we say we will, and we clean up before we go.
Everything we do on a roof, done by crews who have been doing it the same careful way since 2002.
New skylights set into metal or shingle roofs, with the flashing kit the roof actually calls for rather than a tube of sealant.
Removing the ice is the easy half. We also look at ventilation and insulation so it stops happening every January.
A replacement is a big spend and it should feel orderly. We schedule around dry weather, work in the right order, and never leave a house open overnight.
Wind and debris damage is not always obvious from the ground. We check the edges, the ridge, the valleys and the fasteners before telling you anything is fine.
One leak usually has company. We fix the one you called about and check over the rest of the roof while we are already up there.
This is the work our name is attached to. Two decades of tin roofs on houses, churches, barns and additions, installed by crews who cut the trim on site instead of forcing something that almost fits.
Temporary cover goes on fast, then we come back and make the permanent repair once we can see properly what we are working with.
Inspections come free with an estimate. We would rather find the small problem this spring than replace a ceiling for you next winter.
Repair or replace, we handle both, and we work from what the roof actually needs rather than from what an adjuster might approve.
Waterproofing details on additions, porches and low slope tie ins, where two roofs meet and most leaks quietly begin.
We repair standing seam, exposed fastener panels and metal shingles, and we match the color as closely as the paint system will allow.
Most roofs somebody has called a lost cause are not one. We repair what can be repaired, and we tell you honestly when a repair will no longer hold.
Coatings for low slope and older metal roofs that are still sound but weathered. Washed down, refastened, primed at the rust, then coated.
The edge of a roof is where most trouble starts. New fascia, new soffit, wrapped or painted so it stays sound.
Guards installed as part of a roof job or on their own. Either way we check the hangers and the pitch while we are up there.
From a few tabs to a whole slope, we fix shingle roofs without pushing you toward a replacement you are not ready for.
Missing shingles get matched as close as weathering allows. Loose metal gets new fasteners and washers, and the eaves, rakes and ridge get sealed back up tight.
Churches, shops, barns and small commercial buildings. We have roofed everything from a wood shed to a steeple.
Slate and tile take patience and matching pieces. We replace broken and slipped units and rework the flashing they hide.
Where it makes sense we set low slope metal over a problem section so it finally drains instead of ponding after every rain.
Standing seam and metal panels have been our specialty since 2002. Around Hartford that means everything from a small porch roof to a full house in dark green, burgundy or bronze, cut and fit on site by crews who have done hundreds of them.
A metal roof done right in Hartford should be quiet inside, straight from the street, and still there long after you have stopped thinking about it. That takes sound decking, real underlayment, and panels that are actually square. We do not skip those parts to save a day.
Why people around Hartford call us back and send their neighbors our way.
The same family started this company putting metal roofs on neighbors houses in 2002. It has never been sold, franchised or handed off to a call center.
Beds get covered, tear off gets hauled as we go, and a magnet goes over the drive before we pull out. Your yard should look like we were never there.
Around twenty standard metal colors, and the chart comes out with the estimate so you can hold it up against your siding and shutters before you commit.
You get a start date and we hold to it. If weather moves your job we call you, rather than leaving you watching the driveway.
If your roof needs a repair and not a replacement, we say so. Plenty of our best customers are people we talked out of a job they did not need yet.
Straight answers to what Hartford homeowners ask us most often.
Much less than people expect. Over solid decking with underlayment under it, a Hartford metal roof sounds about like a shingle roof from inside the house. The loud tin roof people remember was screwed straight to open purlins over a barn with nothing underneath.
Sometimes. If the decking is sound and there is only one layer of shingles, a Hartford metal roof can go over the top on purlins. If there is rot underneath or two layers already on, we tear off first — and we will tell you that before you sign, not halfway through.
Most Hartford metal roof jobs land somewhere between about $12,000 and $30,000 in 2026, depending on square footage, pitch, panel type and how much tear off there is. Standing seam runs higher than exposed fastener panels. We measure before we quote, and the estimate is free.
Most Hartford houses are a two to four day job. A straightforward shingle roof can be done in a day or two. A cut up metal roof takes longer because every panel, valley and trim piece is measured and fit on site rather than pulled out of a box.
For most Hartford homes, yes. A metal roof costs more up front than shingles, but it usually outlives two or three shingle roofs, sheds rain and snow better, and does not peel off in a hard wind. We will price metal and shingle side by side so you can compare real numbers instead of guessing.
Often, yes. Plenty of the Hartford roofs we get called to look at need flashing reworked or a section refastened, not a whole new roof. We will tell you honestly which one you are looking at, and if it is repairable we would rather repair it.
Real feedback from homeowners whose roofs we have worked on.
"Ice was backing up at our eaves every winter. They cleared it, then went back and fixed the ventilation, and we have not had the problem since."
"Thank you so much to the entire crew at Roofing Brothers for our amazing new tin roof! You were amazing to work with and I couldn't recommend you to others enough! Great communication, pricing, color options, efficiency, and HONESTY! If anyone needs a new roof, I highly recommend this crew! Phenomenal job."
"Old slate roof and I was afraid nobody would touch it. They matched the pieces and now you cannot tell which ones are new."
Our crews cover the surrounding area, not only the city limits.